Micom 3T User Manual download pdf (Page 31)

MI C O M- 3 PC Control & Programming Owner’s Guide

Read Device

The Read Device command enables the user to lo

ad a radio configuration file directly from the radio,

and is similar to the Open

command, which enables the user to load a radio configuration file from

the disk.

Using the Read Device command allows you to load the radio configuration file, perform any

required changes, save the configuration and program the radio.

It is advisable to save the configuration file loaded from the radio on the computer disk (use the

Save command) as a backup file.

Write Device

The Write Device command enables the user to program the radio using serial communication

interface.

Note If the radio is disconnected or turned off during the Write Device operation, the

operation fails and the programming of the radio database will be incomplete. In

such a case, the radio communication operates at a baud rate of 1200 bps. To

communicate with the radio, the MICOM Radio Control application must be

brought to a baud rate of 1200 bps.

When there are configuration errors, the Write Device command on the File menu and the

Write

Device button

on the Toolbar are disabled (grayed). This command remains disabled until the errors

are corrected and the list is clear.

In order to draw your attention to the fact that you cannot load radio parameters while there are

configuration errors, the Configuration Errors

button on the Toolbar is active and the Configuration

Check window comes forward, displaying the error list.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 60 61

No comments

Micom 3T User Manual Page 31